SYSTEM STATUS: ACTIVE

SOP-006: CONTAINMENT INTEGRITY

CAMPAIGN: ASSET (0-12 MONTHS)
TARGET WINDOW: Month 1
PEAR SHAPED
STEP_01

POSITION THE LANDING ZONE

Unfold the clean vessel and place the Asset centered onto the deck. Pull the back panel up significantly higher than you think—it must sit level with the belly button. Low-riding configurations are the primary cause of catastrophic back blowouts.

Back panel height alignment demonstration
LOOP_06.1 // REAR PERIMETER WALL ELEVATION MAXIMIZATION
STEP_02

APPLY THE FORWARD SHIELD

Bring the front panel up between the legs. Secure the left and right fastening tabs firmly to the front grid matrix. The chassis should be snugly contained, not compressed like a corset.

STEP_03

EXECUTE THE WAIST TENSION CHECK

Insert your index and middle finger horizontally into the front waistband. If it feels loose, open the tabs and tighten the structural wrap parameters. If it feels tight, loosen immediately to prevent discomfort marks on the chassis. A proper fit will leave a snug, reassuring resistance against your fingers.

Two-finger horizontal tension calibration check
LOOP_06.2 // TWO-FINGER WAIST REGULATION CALIBRATION
STEP_04

THE MANDATORY FRILL SWEEP (CRITICAL FIREWALL)

Run your index finger completely around the elastic leg cuffs on both sides. Physically flare the outer ruffles and frills completely OUTWARD. If the leg ruffles are left tucked inside, the defensive seal is broken, guaranteeing a dynamic leak down the inner thigh within 10 minutes.

Leg cuff frill outward flaring technique loop
LOOP_06.3 // LEG-CUFF ANTI-BREACH FRILL SWEEP SEQUENCE
LOADOUT MODIFIERS
TECH
+2 PTS

SITREP VERIFICATION DRILL

DRILL 01: What is the primary tactical maneuver required during step 4 to prevent a dynamic leg-cuff breach?

DRILL 02: When anchoring the primary front fastening flaps, what visual metric confirms the internal absorbent core is perfectly centered?